Liquid EPDM Rubber®

F9981 White
F9999 Black
F9988 Gray
F9961 Low Voc

Product Data Sheet

Coverage:
Liquid Rubber ® will cover up to 46 square feet per gallon on a very smooth surface.  Normal coverage is 40-42 square feet per gallon on an average substrate. The required 20-mil film thickness will be achieved when the above spreading rate is used.

Cure Conditions:
The cure rate of Liquid Rubber® is temperature dependent; i.e. higher temperatures will accelerate the cure and lower temperatures will retard it. Contact with air is another requirement. If, for example, a rain shower develops before material has cured [material may still be wet] and water collects on the surface the following condition will prevail. Material that is still wet will prevent water from penetrating the film; however, the curing process will not begin unless material is exposed to air. The material under water will remain uncured until the water has evaporated and the surface again becomes exposed to air, at which time the curing process will begin.

Surface Preparation
Roof surface should be dry and free of dirt and loose gravel at time of application.

Mixing Directions
Proper incorporation and thorough mixing of the catalyst is critical to achieving desired cured film properties and should, therefore, be done with great care. Container is filled low to allow room for mixing as well as the addition of the catalyst. Insert mixing paddle in Liquid Rubber® and mix for approximately one minute so that material is moving uniformly and has formed a vortex. Slowly add catalyst into this vortex at a rate, which allows it to be incorporated without puddling. DO NOT pour catalyst on top of Liquid Rubber® prior to starting mixer. After all the catalyst has been added, the mixer (if hand held) should be moved in a circular fashion around the periphery of the pail as well as up and down to insure that the catalyst is completely and uniformly mixed. Periodically scrape the sides with a rubber or metal spatula to incorporate the stagnant layer of material adhering to walls of pail.

The information presented herein is furnished free of charge and is based on technical data that Pro Guard believes to be reliable. It is intended for use by persons having technical skill and is at their own discretion and risk. Since conditions of use are outside our control we make no warranties, express or implied, and assume no liability in connection with any use of this information. Nothing herein is to be taken as a license to operate or a recommendation to infringe any patents.

Intro
Purchase
Product Data Sheet
Performance And Applications
Acceptable Substrates
Application Guidelines
Manual Application
Spray Application
Contractor Tips
Calculating Material Requirements
Coating Metal Roofs With Liquid Rubber
 
Applications For Wood And Cast Concrete
Coating Cast Concrete
Coating Spalled And Leached Concrete Roof Decks With EPDM Liquid Rubber and Proflex Flexible Epoxy
Coating Wood With EPDM Rubber
Applying Liquid Rubber On Wood & Plywood Roofs And Structures
Structural Designs That Result In Failure Of EPDM Rubber Applied Directly To Plywood
Interaction With WB Elastomeric Coatings
Liquid Rubber and Proflex Primer F1519 For Modified Asphalt Roll Roofing
Pond Procedures
Repairing Pond Liners With Liquid Rubber
Things To Remember When Using Liquid Rubber
Seam Repair For Single Ply EPDM Rubber Roofs
Universal Repair Method For EPDM Rubber
Tech Data
MSDS
Warranty

 

 

Comments are closed.