|
Proflex
Primer®
 |
|
1500 Series |
|
Product Data Sheet |
|
F1500 Clear / Primer |
|
2:1 |
|
|
|
This product is a unique, extremely
flexible, two-component epoxy membrane. It is solvent-free
and exhibits excellent tensile strength and elongation under
ambient as well as colder temperatures. |
|
|
|
ADVANTAGES |
|
|
-
100% solids for low odor during
installation
-
Less hazardous.
-
Self-priming and leveling on properly
prepared surfaces.
-
Self-leveling when sufficient material
is applied.
-
Fills depressions, spalled areas and
cracks.
-
Absorbs movement to help prevent
reflective cracking.
-
Remains flexible over a wide range of
temperatures.
|
|
|
|
|
SURFACE PREPARATION |
|
Surface and air temperature must be a minimum of 50° F.
during installation and initial cure. Surface should
be checked for soundness. Standard surface preparation
practice should be followed, including thorough cleaning and
drying. |
|
|
|
Important Note: It is
important to know that you should not use water or water
based products to clean your concrete. This will effect
adhesion. |
|
|
|
TYPICAL PROPERTIES (When mixed) |
|
Mix Ratio: |
2:1 by volume |
|
Density: |
9.44 |
|
Viscosity (Brookfield): |
750 cps |
|
Gel Time: |
15 min. |
|
Cure Time: |
24 hours |
|
Shore D Hardness (72 hrs): |
52 |
|
Adhesion (aged): |
100% @ 730 psi |
|
Impact Resistance: |
> 174 inch-lbs. |
|
Mandrel Bend: |
1/8” no crack |
|
Color: |
Clear |
|
|
7 days |
15 days |
|
Tensile Strength – Ambient: |
808 psi |
1390 psi |
|
Tensile Strength – Chilled: |
3900 psi |
6610 psi |
|
Elongation – Ambient: |
139 % |
132 % |
|
Elongation – Chilled: |
68 % |
27 % |
|
Modulus of Elasticity – Ambient: |
79.7 psi |
331 psi |
|
Modulus of Elasticity – Chilled: |
1150 psi |
1180 psi |
|
Hot Tire Print |
|
No permanent imprint @
2 hrs., 140°F |
|
|
|
|
|
|
The above data is gathered in a controlled
Laboratory environment. Your conditions will vary.
Pot Life, Gel Time, Dry Time and Cure Time will all
be affected by ambient as well as surface
temperatures. Higher temperatures shorten the time
you have to work with the product. Always mix
thoroughly and immediately pour out of the container
onto the surface to be coated. Only mix the amount
you can easily spread within 30 minutes. If more
specific information is needed please call Pro Guard
Coatings at 800-735-4399 |
|
|
|
|
|
Pro Guard Epoxy™ 2228
