|
Pro Guard Epoxy 2468 |
|
 |
|
This product is a two component, 100%
solids epoxy system for high-build protection of many
substrates. Its ease of use and application, coupled with
its excellent protective properties, makes Pro Guard Epoxy 2468 a
good choice for coating structural substrates in less than
perfect environmental conditions, including dry or damp
concrete or in temperatures between 40 and 50 deg. F.
Pro Guard Epoxy 2468 possesses exceptional bond strength with
concrete. |
|
|
|
|
Technical Data |
|
|
Volume Solids: |
100% |
|
Theoretical Coverage: |
1590 sq ft/gal @ 1 mil DFT |
|
Minimum DFT required: |
5 mils |
|
Number of Coats: |
One or Two |
|
Mixing Ratio: |
1:1 by Volume |
|
Pot Life: |
90 min. @ 70° F. |
|
Cure Time: |
Foot Traffic; Overnight |
|
|
Full Cure; 72 hrs. |
|
Shelf Life: |
1 year minimum (in original closed container) |
|
Color: |
Gray |
|
Storage: |
Store in cool, dry area. For best results material
should be at least 70° F. for mixing and application. |
|
|
|
|
Advantages |
- Convenient 1:1 mixing ratio
- Protects dry as well as damp surfaces
- Has exceptional tensile and bond strength
- Has outstanding chemical resistance
- Abrasion resistance for years of service
- Superior adhesion to common structural substrates
- Ease of use and application with high build
- Lower temperature cures
|
|
Characteristics and Performance |
|
Stormer Viscosity: |
120 KU |
|
Tensile Strength: |
6400 psi |
|
Compressive Strength: |
1 day - 6100 psi |
|
|
7 days - 8900 psi |
|
|
28 days - 9500 psi |
|
|
|
Mixing |
|
Mix each component separately before blending. Measure out
equal volumes of components A and B in a clean container.
Mechanical mixing is necessary for proper blending. Mix only
the amount which can be used within product’s pot life. |
|
|
|
Application |
|
This product is designed to be applied with airless spray,
but brush or roller application is possible in smaller
areas. Thinning should be done sparingly and only when
necessary for spray application. Use Pro Guard Epoxy™ Thinner. |
|
|
|
Limitations |
|
Do not apply over wet substrates or where transmitted vapor
can condense and freeze underneath the coating. Surface
temperature should be above 50 deg. F. and relative humidity
should be 95% or below. New concrete should be aged 3 to 6
weeks prior to application. |
|
|
|
Precautions |
|
FOR INDUSTRIAL USE ONLY. May cause injury to skin following
prolonged or repeated contact. Component B contains alkaline
amine, a strong sensitizer. Do not get in eyes or on skin or
clothing. Avoid breathing vapors. Keep containers closed.
Use with adequate ventilation. Wash thoroughly after use.
Wear protective clothing, eyewear and gloves. KEEP OUT OF
REACH OF CHILDREN. See Material Safety Data Sheet for
further precautions and first aid information. |
|
|
|
|
|
|
Pro Guard Epoxy™ 2228
