|
F9911 EPDM RUBBER SEALANT PRODUCT
DATA SHEET |
|
|
|
F9911 EPDM Rubber Sealant is a
two-component (catalyzed) EPDM rubber compound, which can
cure at ambient temperatures (55° F and above). It can be
used as a caulk, surface sealant, or to create a gasket and
can be applied over rubbers, metals, masonry, fiberglass and
wood. The compound is thixotropic so it can be applied by
brush, spatula or refillable caulk gun. F9911 is designed
for applications requiring a flexible material having a
broad temperature tolerance, chemical and solvent resistance
range. |
|
The cure mechanism requires exposure to
air on one side. If forming a gasket, allow material to cure
on one surface before assembling with a mating surface that
is impervious. The compound contains 35 % volatiles so the
cured dry film will only be 65 % the thickness of the
applied wet film. Do not apply wet films greater than 50
mils thick because the rubber will not be able to cure
through to the center. |
|
|
|
F9911 EPDM Rubber Sealant will experience
35 % shrinkage of the applied film and should only be used
where such a dimensional change is acceptable. Otherwise it
is suitable for use in extreme environments and will
tolerate: |
|
|
- Temperature ranges from minus 60 to +300 degrees F
- High humidity, live steam and total immersion
- High salt concentrations
- Alcohols and polar solvents
- Many acids up to 50 % concentrations
- Caustic solutions to a pH of 12
|
|
************************************************************** |
|
Do not use this product in places where
it will come in contact with oils, fats, waxes, or aliphatic
solvents such as Mineral Spirits, Heptane, Hexane and
similar solvents. |
|
*********************************************************************** |
|
THE PREMEASURED CATALYST SUPPLIED WITH
THE
PRODUCT MUST BE ADDED PRIOR TO APPLICATION |
|
*********************************************************************** |
|
|
WEIGHT |
VOLUME |
Density: |
8.89 |
|
Formula Size: |
893.070 |
100.403 |
Specific Gravity: |
1.07 |
|
Tot. Vehicle: |
73.72% |
91.09% |
P.V.C.: |
13.69% |
|
Pigment: |
26.28% |
8.91% |
P/B Ratio: |
0.566 |
|
Volatile: |
27.32% |
34.87% |
Spread @ 20 mil: |
52 sq ft/gal |
|
Non-Volatile: |
72.68% |
65.13% |
Coating V.O.C.: |
288 G/L |
|
Non-Vol Veh.: |
46.40% |
56.22% |
Mat'l
V.O.C.: |
287 G/L |
|
The
information presented herein is furnished free of charge and
is based on technical data that Pro Guard believes to be
reliable. It is intended for use by persons having technical
skill and is at their own discretion and risk. Since
conditions of use are outside our control we make no
warranties, express or implied, and assume no liability in
connection with any use of this information. Nothing herein
is to be taken as a license to operate or a recommendation
to infringe any patents. |
|
|
Pro Guard Epoxy™ 2228
